Sr770 (2 Tray Finisher) - Ricoh CL7000 Setup Manual

SR770 (2 Tray Finisher)

Preparation
Install the 2 tray finisher after the
optional paper feed unit, optional
memory unit or optional printer
hard disk.
First, install the options that allow
the controller board to be installed,
and then the 2 tray finisher.
R CAUTION:
• When moving the 2 tray finisher,
hold the center of both sides,
and lift slowly. Lifting carelessly
or dropping it may cause injury.
Note
❒ The 2 tray finisher weighs approx-
imately 53 kg (116.9 lbs).
Important
❒ You cannot install the 2 tray finish-
er unless both the paper feed unit
and duplex unit with options are
installed.
❒ The 2 tray finisher requires the op-
tional printer hard disk or optional
memory unit with at least 64 MB
(total memory size 128 MB or
more).
❒ You cannot install the 4-bin mail-
box and 2 tray finisher at the same
time.
A A A A
Turn off the power, and then un-
plug the power cable.
B B B B
Remove the adhesive tape and
packing materials.
Important
❒ Do not remove the adhesive
tape holding the cable yet. Re-
move it in step
S
.
SR770 (2 Tray Finisher)
❖ ❖ ❖ ❖ Front and Side
❖ ❖ ❖ ❖ Back
4
ZDJP059J
ZDJP062J
ZDJP950J
ZDJP060J
81