Ricoh CL7000 Setup Manual page 70

Installing Options
E E E E
Holding the handle, slowly pull
out the controller board.
F F F F
4
Put the controller board down on
a flat surface.
G G G G
Remove the small cover plate us-
ing the provided screwdriver, as
shown.
Note
❒ The removed screws will be
needed in step
58
ZDJP025J
ZHXP140J
I
.
H H H H
Install the 802.11b interface unit
into the controller board. Insert
the tip of the 802.11b interface
unit into the attachment area (A A A A ),
and then push it in the direction
of the arrow (B B B B ).
Check the 802.11b interface unit is
connected firmly to the controller
board.
I I I I
Using the screwdriver provided,
tighten the two screws removed
G G G G
in step , securing the 802.11b in-
terface unit.
ZHXP030J
ZHXP130J