Ricoh CL7000 Setup Manual page 59

H H H H
Press the memory unit down until
it clicks into the locked position.
I I I I
Align the controller board with
the top and bottom rails, and then
push in slowly, until it stops.
J J J J
Tighten the two screws fastening
the controller board back into its
original position, using the pro-
vided screwdriver.
Memory Unit TypeC (SDRAM Module)
Note
❒ Be sure to return the provided
screwdriver to its original posi-
tion on the inside of the front
cover.
❒ After finishing the installation,
you can check the memory unit
is installed properly: Print the
configuration page from the
"List/Test Print" menu. If it is
installed properly, you will see
the memory capacity for "Total
ZDJP029J
Memory".
❒ If the memory unit is not in-
stalled properly, repeat the pro-
cedure from step
cannot install it properly even
after reinstallation, contact your
sales or service representative.
Reference
p.23 "Test Printing"
ZDJP030J
ZDJP031J
4
A
. If you
47