Ricoh CL7000 Setup Manual page 84

Installing Options
L L L L
Bind the connectors with the
clamp, as shown.
M M M M
4
Push the clamp hook back in the
direction of the arrow, until it
clicks.
N N N N
Connect the power cable to the
controller board.
72
O O O O
Align the controller board with
the top and bottom rails, and then
push in slowly, until it stops.
ZHXP360J
P P P P
Tighten the two screws fastening
the controller board back into its
original position, using the pro-
vided screwdriver.
ZHXP370J
The printer hard disk automatical-
ly begins formatting when the
printer is switched on.
Note
❒ Be sure to return the provided
screwdriver to its original posi-
tion on the inside of the front
cover.
ZHXP340J
ZDJP030J
ZDJP031J