Ricoh CL7000 Setup Manual page 73

G G G G
Press { { { { U U U U } } } } or { { { { T T T T } } } } to select the
transmission mode.
Note
❒ The default is "802.11 Ad hoc".
❒ To use an IEEE 802.11b card for
w h i c h t h e S S I D ( N e t w o r k
Name) setting is not necessary,
select "Ad hoc".
H H H H
Press { { { { Enter #} } } } .
After a few seconds, the display re-
turns to the previous menu.
I I I I
If "802.11 Ad hoc" or "Ad hoc" is
selected for "Comm. Mode", set
the channel for transmission.
Note
❒ Check with the network admin-
istrator about the channel to
use.
A Press { { { { U U U U } } } } or { { { { T T T T } } } } to display
"Channel".
IEEE 802.11b:
Channel
B Press { { { { Enter #} } } } .
The channel currently in use ap-
pears on the display.
Channel:
(1-11)
C Press { { { { U U U U } } } } or { { { { T T T T } } } } to enter the
channel.
D Press { { { { Enter #} } } } .
J J J J
Set "Trans. Speed" in the same
way.
Note
❒ The default is "Auto". If you
need to change the transmitting
speed depending on the envi-
ronment you are using, select
the appropriate speed.
K K K K
11
802.11b Interface Unit Type A
Press the { { { { U U U U } } } } or { { { { T T T T } } } } key to dis-
play "SSID", and then press the
{ { { { Enter #} } } } key.
IEEE 802.11b:
SSID
The following message appears on
the display:
SSID:
Enter ID
Note
❒ The default is "ASSID".
❒ If an SSID has been set, you can
check it. Press the { { { { U U U U } } } } or { { { { T T T T } } } }
key to display "View", and then
press the { { { { Enter #} } } } key.
A Press the { { { { Enter #} } } } key.
The following message appears
on the display:
SSID:
k
Note
❒ The value in brackets at the
upper right indicates the
number of characters en-
tered.
B Press the { { { { U U U U } } } } or { { { { T T T T } } } } key to se-
lect characters, and then press
the { { { { Enter #} } } } key.
SSID:
A
The cursor (k) moves to the next
character position.
SSID:
Ak
4
[ 0]
[ 1]
[ 1]
61