Ricoh CL7000 Setup Manual page 74

Installing Options
C Continue entering.
Note
❒ Usable characters are ASCII
0x20-0x7e (32 bytes).
❒ If you press the { { { { Escape} } } } key,
the cursor (k) moves to the
previous character position.
D After entering, press the { { { { Enter
#} } } } key twice.
SSID:
AAAAAAAAAAAAAAAA
4
The screen returns to step
L L L L
Press the { { { { U U U U } } } } or { { { { T T T T } } } } key to dis-
play "WEP Setting".
IEEE 802.11b:
WEP Setting
A Press the { { { { Enter #} } } } key.
WEP Setting:
*Not Active
B Press the { { { { U U U U } } } } or { { { { T T T T } } } } key to dis-
play "Active", and then press
the { { { { Enter #} } } } key.
WEP Setting:
Active
The following message appears
on the display:
Change WEP Key:
Yes
Note
❒ When setting WEP to "Ac-
tive", you need to enter the
WEP key. If you have not en-
tered the key, be sure to enter
it.
62
C Press the { { { { Enter #} } } } key.
[32]
K
.
D Press the { { { { U U U U } } } } or { { { { T T T T } } } } key to se-
E Continue entering.
❒ If you have entered the WEP
key, and then change the set-
ting, press the { { { { U U U U } } } } or { { { { T T T T } } } }
key to display "No", and
then press the { { { { Enter #} } } } key.
WEP Key:
k
Note
❒ The value in brackets at the
upper right indicates the
number of characters en-
tered.
lect characters, and then press
the { { { { Enter #} } } } key.
WEP Key:
0
The cursor (k) moves to the next
character position.
WEP Key:
0k
Note
❒ You can enter either 10 or 26
characters. If the key you en-
ter is not 10 or 26 characters
long, the following message
appears:
Error: Enter 10
or 26 characters
❒ If you press the { { { { Escape} } } } key,
the cursor (k) moves to the
previous character position.
[ 0]
[ 1]
[ 1]