Ricoh CL7000 Setup Manual page 61

D D D D
Remove the two screws fastening
the controller board to the back of
the printer using the provided
screwdriver.
The removed screws will be used
later to fasten the controller board.
E E E E
Holding the handle, slowly pull
out the controller board.
F F F F
Put the controller board down on
a flat surface.
G G G G
Remove the small cover plate us-
ing the provided screwdriver, as
shown.
Note
❒ The removed screws will be
needed in step
H H H H
Install the 1394 interface unit into
the controller board. Insert the tip
of the 1394 interface unit into the
attachment area (A A A A ), and then
push it in the direction of the ar-
row (B B B B ).
ZDJP025J
Check the 1394 interface unit is
connected firmly to the controller
board.
I I I I
Using the screwdriver provided,
tighten the two screws removed
in step
face unit.
ZDJP025J
ZHXP140J
1394 Interface Unit Type 4510
I
.
G G G G
, securing the 1394 inter-
4
ZHXP040J
ZHXP131J
49