Ricoh CL7000 Setup Manual page 67

E E E E
Holding the handle, slowly pull
out the controller board.
F F F F
Put the controller board down on
a flat surface.
G G G G
Remove the small cover plate us-
ing the provided screwdriver, as
shown.
Note
❒ The removed screws will be
needed in step
ZDJP025J
ZHXP140J
I
.
USB 2.0 Interface Board Type A
H H H H
Install the USB 2.0 interface
board into the controller board.
Insert the tip of the USB 2.0 inter-
face board into the attachment
area (A A A A ), and then push it in the
direction of the arrow (B B B B ).
Check the USB 2.0 interface board
is connected firmly to the control-
ler board.
I I I I
Using the screwdriver provided,
tighten the two screws removed
G G G G
in step , securing the USB 2.0 in-
terface board.
4
ZHXP020J
ZHXP132J
55