Toshiba Stratagy 4 Installation And Maintenance Manual page 88

STRATAGY 4/6/24
INSTALLATION AND MAINTENANCE MANUAL SEPTEMBER 1994
PARAMETER
DESCRIPTION
# DIAL CODE TO PUT A CALLER ON TRANSFER HOLD:
Before Stratagy attempts to transfer a caller to an extension, the code Stratagy sends the telephone
system to put the current call on "transfer hold" and send the transfer (or intercom) dial tone.
Typical value: F- (flash-hook)
# DIAL CODE TO USE WHEN THERE IS NO TRANSFER DIALTONE:
If Stratagy is configured to verify that transfer dial tone exists before attempting to transfer a call to the
requested extension, the code Stratagy dials to return to the caller if transfer dial tone is not available. If
this occurs, Stratagy will treat the attempted transfer the same as if the attempted extension were BUSY.
Typical value: F- (flash-hook)
# DIAL CODE TO RETURN TO CALLER AFTER RING NO ANSWER:
During supervised call transfers, the code Stratagy dials to request the telephone switch to reconnect the
caller to Stratagy if the attempted extension rings and does not answer within the specified number of
rings (which is configurable per User ID).
Typical value: F- (flash-hook)
# DIAL CODE TO RETURN TO CALLER WHEN THERE IS A BUSY:
During supervised call transfers, the code Stratagy dials to request the telephone switch to reconnect the
caller to Stratagy if the attempted extension is busy.
Typical value: F- (flash-hook)
# DIAL CODE TO USE AFTER A CALL SCREENING REJECT:
During supervised call transfers, with Call Screening ON, if the extension called rejects the caller, the
code Stratagy dials to reconnect to the caller and play the User ID's current greeting.
Typical value: F- (flash-hook)
# DIAL CODE TO CONNECT THE CALLER TO THE EXTENSION:
Dial code Stratagy dials during supervised call transfers to complete the call transfer either after detecting
an answer at the called extension, or if Call Screening is ON, after the extension called accepts the call.
Typical value: H (Hang Up)
# NUMBER OF SECONDS TO WAIT FOR DIALTONE DETECTION:
If your telephone system has a limited number of DTMF receivers, or intercom paths for call transfers,
and potentially might not have one always available to Stratagy for a call transfer, enable Stratagy's dial
tone detection by setting this value greater than 0. The value is the longest amount of time Stratagy will
wait for the telephone system to give Stratagy I second of dial tone.
Typical value: 4
# NUMBER OF l/l 00 SECONDS TO USE FOR FLASH TIME:
Time Stratagy must remain on-hook while performing a flash-hook.
Typical value: 55 (just over half a second)
,
Table 5-2
Telephone System Dial Codes - Parameters and Definitions
5-27