Toshiba Stratagy 4 Installation And Maintenance Manual page 176

STRATAGY 4/6/24
INSTALLATION AND MAINTENANCE MANUAL
SEPTEMBER 1994
TOKEN
1 FUNCTION 1
Defined Tokens (continued)
DEFINITION
R( ) Read DTMF from
Syntax: R(Gn,%Sm,de/ay)
a caller.
Where:
Gn Greeting number for the current User ID (range 1 - 7).
%Sm One of the %S storage variables (range: 0 - 9).
delay Time in tenths of seconds to wait for DTMF after
playing the greeting (range: 0 - 99). If omitted,
defaults to 0.
Description: The R( ) token allows you to obtain caller information
while prompting the caller with the specified recorded greeting. The token
plays the greeting specified for the current User ID and allows the caller
to make DTMF entry which is stored in the specified %S variable.
Stratagy interrupts the greeting as soon as the caller enters the first
DTMF tone. If there is no caller DTMF entry, Stratagy initializes the %S
variable to empty, i.e., "'I.
Example: To prompt and have a caller enter a telephone number and
have Stratagy store that telephone number to be used later, you could:
n Record in greeting 1: "Enter your telephone number. Finish by
pressing the # sign."
n Use R(GI ,%S6,20), which:
l
Plays greeting 1.
l
Stores the caller's entry in variable %S6.
l
Waits 2 seconds (20 + 10 = 2) for DTMF after playing the
greeting.
S( ) Serial port access. Syntax: S(port, "9, %Sn, "termination",length, timeout)
Where:
port Logical serial port (1 or 2) mapped onto a physical
port number by the Setup Utility configuration option
serial-port1 for logical port 1 or serial-port2for logical
port 2 (Section 2, /nsta//ation).
"S" String sent out on the specified port. It may contain
any alphanumeric characters, %S variables, and the
following special characters:
\A Attention (bell sound), or Ctrl + G
\N Newline, or Ctrl + J
\R Return, or Ctrl + M
\T Tab, or Ctrl + I
\\ Backslash, the actual \ character
%Sn One of the %S storage variables (range: 0 - 9), which
stores any response from the serial port. If omitted,
Stratagy will not wait for a response.
"termination " List of characters that defines when Stratagy should
stop reading from the serial port for storing in the
specified %Sn variable. If omitted, defaults to "IN\R"
as specified under "S'. The terminating character, if
any, will not be pat-t of %Sn.
*Tm".tNSIzo
Table 6-2
Token Programming Language Tokens (continued)
6-l 0