Toshiba Stratagy 4 Installation And Maintenance Manual page 181

STRATAGY 4/6/24
INSTALLATION AND MAINTENANCE MANUAL SEPTEMBER 1994
TOKEN
( FUNCTION
DEFINITION
Defined Tokens (continued)
I( ) kp$Fd variables
Syntax: I(We)
Where:
file Any valid DOS file name. Use two backslashes \\ to
signify one backslash \. For example, to specify the file
name C:\STRATAGY\NEW.TXT, use
C:\\STRATAGY\\NEW.TXT.
[() Read %S
variables state.
Description: Writes all ten %S variables (%SO through %S9) to the
specified file. If the file already exists, the variable values are appended
to the file; otherwise, the file is created. The values are separated by
commas and terminated by a new line.
Syntax: [(file)
Where:
file Any valid DOS file name. Use two backslashes \\ to
signify one backslash \. For example, to specify the file
name C:\STRATAGY\NEW.TXT, use
C:\\STRATAGY\\NEW.TXT.
Description: Reads the values of all ten %S variables (%SO - %S9)
from the specified file. The format expected is a one line, comma
delimited, ASCII file where the first value is %SO, the second is %Si, etc.
When the [( ) token is used with the ]( ) token, you can read, modify, and
write (remember) %S variables.
NOTE:
To avoid potential simultaneous access errors: within the
same User ID, if you read with the [() token, you should
write with the]0 token.
]( ) Write %S Syntax: ](fi/e)
variables state.
Where:
file Any valid DOS file name. Use two backslashes \\ to
signify one backslash \. For example, to specify the file
name C:\STRATAGY\NEW.TXT, use
0
C:\\STRATAGY\\NEW.TXT.
Description: Writes the values of all ten %S variables (%SO - %S9) to
the specified file. Typically, you would use this with the [( ) token which
reads the %S variables.
NOTE:
90 Changeport
volume.
To avoid potential simultaneous access errors: within the
same User ID, if you read with the [() token, you should
write with the]0 token.
Syntax: A(@
Where:
n Volume of current port (range: -8 to 8).
-8 is the softest
0 is the default initial volume
8 is the loudest.
Description: Changes the volume of the current port to the specified
level.
Table 6-2
Token Programming Language Tokens (continued)
6-15