Toshiba Stratagy 4 Installation And Maintenance Manual page 81

STRATAGY 4/6/24
INSTALLATION AND MAINTENANCE MANUAL
SEPTEMBER 1994
,
PARAMETER
fax-send-speed
fax-start-char
fax1
fax2
smdi-base-port
smdi-port
DESCRIPTION
Maximum speed that Stratagy will use for sending faxes. Depending upon the
type and speed of your computer set this appropriately. Normally a value of 3
works for 386 CPUs at 33 MHz or higher. If you experience data loss on your
faxes, lower this setting.
': (empty string) as fast as possible
'0': 2400
'1': 4800
'3': 9600
Possible values: ", 'O', 'I', '3'
The single quotes are required.
Default: '1'
Stratagy 24 only.
Whether the fax/modem sends a control start character.
FALSE Setting for most fax/modems, including Zoom.
TRUE: Setting for some fax/modems, including Accex and Practical Peripherals.
Possible values: true, false
Default: true
Stratagy 24 only.
Station, or extension, number connected to the first fax/modem.
Example: If the first fax/modem is connected to extension 101, use the value '101'.
The single quotes are required.
Default: ' ' (no station or extension number)
Stratagy 24 only.
Station, or extension, number connected to the second fax/modem.
Example: If the second fax/modem is connected to extension 102, use the value
'102'. The single quotes are required.
Default: ' ' (no station or extension number)
Stratagy 24 only.
Some SMDI installations use logical terminal numbers that do not begin with 1
(for example if it instead uses the extension, or physical number to define the
terminal). In these situations, you must define the extension number where port 1
is connected. The system assumes that the extension numbers are then
connected in numerical order to the remaining ports.
Default: 1
Stratagy 6 and 24 only.
Logical serial port Stratagy uses for SMDI integration.
Possible values: 0 (disables SMDI integration), 1, 2 (port number)
Default: 0
Stratagy 6 and 24 only.
Table 5-1
Stratagy System Configuration Options - Parameters and Definitions (continued)
5-20