Toshiba Stratagy 4 Installation And Maintenance Manual page 75

STRATAGY 4/6/24
INSTALLATION AND MAINTENANCE MANUAL
SEPTEMBER 1994
,
PARAMETER
tmo-blank
DESCRIPTION
Total number of minutes Stratagy waits before blanking the Main Menu screen to
prevent screen burn-in.
NOTE:
This option only blanks the screen if the current screen is the Main Menu.
Possible values: 0 (disabled), 1 - 99 (minutes)
Default: 5
tmo-dtmf Amount of time Stratagy waits to determine that the caller has finished entering
DTMF digits (provided that they do not press the #). In units of 100 ms.
Possible values: 10 - 99 (units of 100 ms)
Default: 12
tmo-hold Number of seconds before Stratagy attempts to transfer a caller after the caller
has pressed * to hold for a busy extension.
When a caller presses * to hold for a busy extension, Stratagy plays a file called
C:\Stratagy\HOLD.VOX after which Stratagy attempts to transfer the caller again.
If that file is missing, Stratagy is silent for the number of seconds specified by this
option.
NOTE:
To have callers hear a specialty recording while on hold, record over HOLD. VOX
by accessing the System Administration Menu. See the Programming section,
Chapter 5, "System Administrator's User ID" for details.
Default: 20 (seconds)
tmo-idle When this value is greater than 0, it enables a special function in Stratagy to go
off-hook and back on-hook whenever a port is idle for the specified number of
seconds. This is necessary only under rare circumstances when a telephone
switch may not release a station that is connected to Stratagy even after Stratagy
has gone on-hook.
Default: 0
tmo-menu Amount of time Stratagy waits before repeating a choice menu. In units of 100
ms.
Possible values: 1 - 99 (units of 100 ms)
Default: 20
tmo-pickup Minimum amount of time the system waits between an on-hook and off-hook
event. In units of 100 ms.
Possible values: 10 - 99 (units of 100 ms)
Default: 20
Table 5-1
Stratagy System Configuration Options - Parameters and Definitions (continued)
5-14