Table of Contents
Advertisement
Plus d'informations sur : www.dbmoteurs.fr
Adjustments and Benchtesting
Measure V-belt deflection
Measure the deflection of the belt. Apply approxi-
mately 98 to 147 N (10 to 15 kgf) [22 to 33 lbf] force
midway between the pulleys. The deflection should
be approximately 10 to 15 mm [0.4 to 0.6 in.]. Adjust
the belt if the deflection is not correct.
Alternator
1. Remove the V-belt cover.
2. Loosen the mounting bolts (1) of the alternator
and the adjusting rod(2).
3. Loosen the upper- and lower-side lock nuts (3) of
the adjusting rod.
NOTE! Turn the nut below the adjusting rod to the left
to tighten.
4. Set the tension of the V-belt properly by turning
the adjusting rod (2).
5. After setting the tension, tighten the upper- and
lower-side lock nuts.
6. Tighten the mounting bolts to fix the alternator.
7. Set the belt cover and front cover properly.
Raw water pump
1. Remove the front belt cover.
2. Loosen the tension pulley bracket(1) mounting
bolts(2).
3. While loosening lock nut(3), turn the adjusting
bolt(4) and set the tension of belt properly.
4. While maintaining this condition, tighten lock nut
and the mounting bracket bolts.
5. Set the front belt cover properly.
59
Advertisement
Table of Contents
