Table of Contents
Advertisement
Group 26 Cooling System
198
Plus d'informations sur : www.dbmoteurs.fr
1. Install the cam to the casing, and tighten the
screw to the specified torque. The contact surfac-
es must be coated with ThreeBond 1102.
2. Install the unit seal to the bushing by striking with
a hammer, making sure the unit seal remains
square to the bushing during installation. The
contact surface must be coated with ThreeBond
1102
NOTE! Be sure to replace the unit seal with a new
part
3. Using a jig and a hammer, install the bearing to
the shaft, making sure the bearing remains
square to the center line of the shaft.
4. Install the slinger (A) to the holder. Install the
bushing (B) with unit seal to the holder. Clean the
sliding surface (C) on the seat side of the unit
seal with ethyl alcohol, then coat with turbine oil.
Install the seat side (D) onto the shaft, and fasten
with the snap ring (E).
Advertisement
Table of Contents
