Table of Contents
Advertisement
Plus d'informations sur : www.dbmoteurs.fr
Install the idler shaft thrust collars
1. Apply grease to the thrust collars, and insert the
collars in the timing gear case.
In this step, make sure the "TOP" mark is located
at the top and that the right and left collars are in-
stalled in their original positions.
2. Tighten the thrust collar mounting nuts to the
specified torque.
3. Install the cover, and tighten the mounting bolts
to the specified torque.
Installing the flywheel
1. Install the flywheel. Check that all dowel pins en-
ter their holes.
2. Coat the threads and the bolt bearing surface of
the flywheel mounting bolts with engine oil. Tight-
en the bolts to the specified torque. Inspect the
face and radial runouts of the flywheel.
Installing the pickup
1. Rotate the engine using the turning gear until a
tooth of the ring gear is positioned at the center of
the pickup mounting hole.
2. Screw the pickup gently, by hand, into the hole.
When the tip of the pickup contacts the tooth sur-
face of the ring gear, loosen the pickup 1½ turn,
then tighten the lock nut to secure the pickup in
place.
NOTE! Installing the pickup too close to the teeth of
the ring gear may result in too strong a signal.
Group 21 Engine Body
127
Advertisement
Table of Contents
