Volvo Penta D65A MS Workshop Manual page 39

Pinion shaft diameter (front), mm [in.]
Nominal Value ............ Ø19 [0.75]
Assembly Standard .... (18.90 to 18.94) ([0.7441 to 0.7457])
Reapir Limit ................ Ø19 +0.06
+0.10
Metal, Pinion
Nominal Value ............ Ø19 [0.75]
Assembly Standard .... 19.000 to 19.033 [0.7480 to 0.7493]
+0.033
Reapir Limit ................ Ø19
Service Limit .............. 0.25 [0.0098]
NOTE! Clearance between shaft and metal.
End play of armature, mm [in.]
Assembly Standard .... 0.3 to 0.7 [0.012 to 0.028]
End play of pinion shaft, mm [in.]
Assembly Standard .... 0.2 to 0.8 [0.008 to 0.031]
Alternator
Output current (27 V), 2500 rpm
At 2500 rpm:
Assembly Standard .... 30 A or higher when cold
At 5000 rpm:
Assembly Standard .... 35 A or higher, when hot
Regulator adjusting voltage (alternator at 5000
rpm, load at 5 A or lower)
Assembly Standard .... 28.5±0.5 V
Field coil resistance (at 20°C [68°F])
Assembly Standard .... 7.3 to 8.6 Ω
Plus d'informations sur : www.dbmoteurs.fr
[0.75 +0.00236 ]
+0.00394
+0.00130
[0.75 ]
0
0
Maintenance Standards
39