Volvo Penta D65A MS Workshop Manual page 199

Plus d'informations sur : www.dbmoteurs.fr
5. Install the casing to the holder via the plate. The
contact surface must be coated with ThreeBond
1102. Tighten the bolts to 7.4 to 9.8 N*m (0.75 to
1.0 kgf*m) [5.42 to 7.23 lbf*ft].
6. Install the impeller to the shaft by striking with a
hammer.
NOTE! Make sure the impeller vane tips are pointed
in the direction opposite to the rotational direction.
7. Install the O-ring to the casing, and mount the
cover. Tighten the bolts to the specified torque.
8. Tighten the nut to secure the pulley in place
(tightening torque: 196 N*m (20 kgf*m) [144.7
lbf*ft])
Group 26 Cooling System
199