Table of Contents
Advertisement
Plus d'informations sur : www.dbmoteurs.fr
Installing camshaft gears
1. Install the camshaft gears to meet the dowel pin.
2. Tighten the camshaft gear mounting bolts to the
specified torque.
3. After installing the camshaft gear, check that the
gear rotates smoothly.
Installing idler gears
1. Install the idler gear by aligning its matching mark
with that on the crankshaft gear and camshaft
gear. Tighten the idler gear mounting bolts to the
specified torque.
2. Insert the slinger to the crankshaft.
3. Confirm that the matching marks of the timing
gears are as the drawing shown on the right.
Installing the injection pump drive
1. Install the injection pump gear to the drive shaft,
then tighten it to the specified torque. 392 N.m
(40 kgf.m) [289 lbf.ft]
2. Fit the O-ring to the installation surface of the
drive case. Apply a thin coat of ThreeBond 1212
on the flange surface.
3. Install the injection pump drive to the rear plate
by aligning its matching mark to that of the idler
gear.
4. Tighten the drive case mounting bolts to the
specified torque. 108 N.m (11 kgf.m) [80 lbf.ft]
Group 21 Engine Body
125
Advertisement
Table of Contents
