Volvo Penta D65A MS Workshop Manual page 15

Plus d'informations sur : www.dbmoteurs.fr
Bearings
1. When installing a rolling bearing, be sure to push
the inner or outer race by which the bearing is fit-
ted. Be sure to use a bearing driver like the one
shown.
2. Whenever possible, use a press to minimize
shock to the bearing and to assure proper instal-
lation.
Lock Plates
Bend lock plates against the flats of the nuts or bolt
heads as shown.
Split Pins and Spring Pins
Generally, split pins are to be replaced once dis-
turbed. Insert the pin fully and spread it properly.
Drive each spring pin into position to hold it in place
after later installation of parts has been completed.
General information
15