Table of Contents
Advertisement
Plus d'informations sur : www.dbmoteurs.fr
Group 25 Inlet and Exhaust System
Removing the shaft & turbine wheel
1. Remove the bolts and lock plates.
2. While gripping the shaft of the shaft & turbine
wheel with one hand, hold the bearing housing
with the other hand and slowly remove the shaft
& turbine wheel from the turbine housing.
3. Turn the bearing housing (turbine wheel face up)
and place it on the compressor cover. Remove
the shaft and turbine wheel, the piston ring, the
turbine backplate and the bearing(compressor
side).
Removing the snap ring and bearing
IMPORTANT! Remove the snap ring with care
and make sure not to damage the inside sur-
face of the bearing house or the seal (turbine
side) of the piston ring.
Place the bearing housing on a workbench with the
compressor side face up. Then remove the 3 snap
rings and the bearing.
179
Advertisement
Table of Contents
