Ipqos Config - THOMSON speedtouch 610 Cli Reference Manual

IPQoS Commands

ipqos config

Configure Internet Protocol (IP) Quality of Service (QoS) for a given destination interface for the IP QoS queues
instantiation.
When enabling/disabling of IP QoS, take the following into account:
Note
•
if the WAN interface (e.g. PPPoA, IPoA, ...) is detached at the time of enabling/disabling IP QoS, then
the WAN interface has to be attached in order for the enabling/disabling of IP QoS to take effect.
•
if the WAN interface is attached at the time of enabling/disabling IP QoS, then the WAN interface has
to be detached and then re-attached in order for the enabling/disabling of IP QoS to take effect.
SYNTAX:
ipqos config
where:
dest
state
discard
266
dest = <string>
[state = <{disabled|enabled}>]
[discard = <{tail|early}>]
[priority = <{wfq|strict}>]
[realtimerate = <number{1-100}>]
[burstsize = <number{1-128}>]
[weight1 = <number{1-97}>]
[weight2 = <number{1-97}>]
[weight3 = <number{1-97}>]
[weight4 = <number{1-97}>]
[maxpackets = <number{0-100}>]
[maxbytes = <number{0-128}>]
The destination interface for the IP QoS queues instantiation.
This is a phonebook entry.
This parameter enables or disables IP QoS for the interface.
The default is disabled.
Determines the packet discard strategy in case of congestion.
Choose between:
•
tail:
Tail Drop: arriving packets will be dropped as soon as the
destination queue is in an overflow state.
•
early:
Early Packet discard: arriving packets will be dropped early
according to the BLUE active queue management algorithm.
The default is early.
REQUIRED
OPTIONAL
OPTIONAL
E-DOC-CTC-20040210-0028 v3.0