Switch Mirror Ingress - THOMSON speedtouch 610 Cli Reference Manual

switch mirror ingress

Enable or disable the specified port to be the Mirror Ingress Port.
Only one port can be the Mirror Ingress Port at any one time.
Note
But a port can be the Mirror Egress Port and the Mirror Ingress Port at the same time.
SYNTAX:
switch mirror ingress
where:
port
state
EXAMPLE:
Here port 2 is enabled as Mirror Ingress Port
=>switch mirror ingress port=2
=>switch mirror ingress
Ingress mirror port = 2
Here port 2 is disabled as Mirror Ingress Port
=>switch mirror ingress
Ingress mirror port = 2
=>switch mirror ingress port=2 state=disabled
=>switch mirror ingress
=>
RELATED COMMANDS:
switch mirror capture
switch mirror egress
E-DOC-CTC-20040210-0028 v3.0
port = <number{1-4}>
[state = <{enabled|disabled}>]
The port to be the Mirror Ingress Port.
If no port number is specified, then the port number of the current
Mirror Ingress Port is shown.
This parameter permits to enable/disable a port as Mirror Ingress
Port.
Define the specified port to be the Mirror Capture Port.
Enable or disable the specified port to be a Transmitted Port Mirroring.
Switch Commands
REQUIRED
OPTIONAL
513