THOMSON speedtouch 610 Cli Reference Manual page 404

PPPoA Commands
srcmsk
metric
EXAMPLE:
=>pppoa iflist
pppoa1: dest : pppoa
Retry : 10 QoS default
mode = IP routing
flags = echo magic accomp restart mru addr route savepwd
dns metric = 0
route : dst=0.0.0.0/0 - src=10.0.0.0/1 (metric 1)
auth = auto user = johndoe@ISP
admin state = up
LCP : state = starting
IPCP: state = initial
=>pppoa rtadd intf=pppoa1 dst=172.16.0.5 dstmsk=24 src=10.0.0.2 srcmask=24
=>pppoa iflist
pppoa1: dest : pppoa
Retry : 10 QoS default
mode = IP routing
flags = echo magic accomp restart mru addr route savepwd
dns metric = 0
route = 10.0.0.2/24 - 172.16.0.5/24 (metric 1)
auth = auto user = johndoe@ISP
admin state = up
LCP : state = starting
IPCP: state = initial
=>
RELATED COMMANDS:
pppoa rtdelete
402
The source IP mask.
Depending on the source netmask:
•
Everybody is allowed to use this PPPoA connection (srcmsk=0)
•
Only members of the same subnet as the host which opened the
PPPoA connection are allowed to use the PPPoA connection
(srcmsk=1)
•
The actual destination mask will be the netmask applicable for the IP
address of the host which opened the PPPoA connection.
•
Only the host which opened the PPPoA connection is allowed to
use the PPPoA connection (srcmsk=32)
•
Any valid (contiguous) netmask in case of VLSM.
A number between 0 and 100.
Represents the route metric, i.e. the cost factor of the route.
Practically, the cost is determined by the hop count.
[00:00:00]
encaps VC-MUX
trans addr = pat mru = 1500
password = ********
oper state = down
retransm = 1
retransm = 0
[00:00:00]
encaps VC-MUX
trans addr = pat mru = 1500
password = ********
oper state = down
retransm = 1
retransm = 0
Delete the route specification for an upcoming PPPoA link.
link state = not-connected
term. reason =
term. reason =
link state = not-connected
term. reason =
term. reason =
OPTIONAL
OPTIONAL
E-DOC-CTC-20040210-0028 v3.0