THOMSON speedtouch 610 Cli Reference Manual page 269

priority
realtimerate
burstsize
weight1
weight2
weight3
weight4
maxpackets
maxbytes
E-DOC-CTC-20040210-0028 v3.0
Select the queue scheduling algorithm. Choose between:
•
wfq:
Weighted Fair Queueing (WFQ) is used for the middle four queues.
The realtime queue has priority over the WFQ queues, which have
priority over the best-effort queue.
•
strict:
Priority queueing is used.
Strict Priority scheduling is used between all queues. The higher the
queue number, the higher the priority.
The default is wfq.
A number between 1 and 100.
Represents a percentage of the interface bandwidth for rate-limiting of
the Real Time queue.
In case of congestion, the Real Time queue will only use this percentage of
the interface bandwidth when there is also traffic on the other queues.
The default is 80.
A number between 1 and 128.
Represents the realtime queue burstsize (in kilobytes) for rate limiting.
The default is 2.
A number between 1 and 97.
Represents the weight of queue 1 used for WFQ. The default is 25 (%).
A number between 1 and 97.
Represents the weight of queue 2 used for WFQ. The default is 25 (%).
A number between 1 and 97.
Represents the weight of queue 3 used for WFQ. The default is 25 (%).
A number between 1 and 97.
Represents the weight of queue 4 used for WFQ. The default is 25 (%).
A number between 0 and 100.
Represents the maximum number of packets in all IP QoS queues
instantiated for one interface.
The default is 0.
The value 0 implies that no upper limit on the maximum
Note
number of packets is enforced for the total of all instantiated
queues per destination.
A number between 0 and 128.
Represents the maximum size in kilobytes in all IP QoS queues
instantiated for one interface.
The default is 0.
The value 0 implies that no upper limit on the maximum
Note
number of kilobytes is enforced for the total of all instantiated
queues per destination.
IPQoS Commands
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
267