Bridge Ifconfig - THOMSON speedtouch 610 Cli Reference Manual

Bridge Commands

bridge ifconfig

Configure a bridge interface.
SYNTAX:
bridge ifconfig
where:
intf
dest
qos
encaps
fcs
portstate
retry
68
intf = <intfname>
[dest = <string>]
[qos = <string>]
[encaps = <{llc/snap|vcmux}>]
[fcs = <{off|on}>]
[portstate = <{disabled|learning|forwarding}>]
[retry = <number {0-65535}>]
The name of the bridge interface to configure.
The destination for this interface. Typically a phonebook entry.
This parameter only needs to be specified when an interface has
been created without specified destination.
The name of the Quality Of Service (QoS) book entry to apply on
this bridge interface.
The type of encapsulation to be used for this bridge interface.
Choose between:
•
llc/snap
•
vcmux.
Whether or not to include the Ethernet FCS in the packet header on
the WAN side. Choose between:
•
off
•
on.
The default is off.
FCS is normally left off.
Note
The bridge portstate for this interface.
Choose between:
•
disabled
•
learning
•
forwarding.
A number between 0 and 65535.
Represents the number of times the SpeedTouch™ retries to set up
a WAN connection before giving up.
The default is 10.
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20040210-0028 v3.0