Pppoa Rtadd - THOMSON speedtouch 610 Cli Reference Manual

pppoa rtadd

Automatically add a route configuration to the routing table in case the specified PPPoA interface link comes up.
This route configuration will determine which local hosts are allowed to use this link and/or which remote destinations
should be or should not be reachable.
Use the command pppoa ifdetach for this interface prior to configuring routes.
Note
SYNTAX:
pppoa rtadd
where:
intf
dst
dstmsk
label
src
E-DOC-CTC-20040210-0028 v3.0
intf = <intfname>
dst = <ip-address>
[dstmsk = <ip-mask(dotted or cidr)>]
[label = <string>]
[src = <ip-address>]
[srcmsk = <ip-mask(dotted or cidr)>]
[metric = <number{0-100}>]
The name of the PPPoA interface.
The destination IP address for the route to be added when the link comes
up.
The destination IP mask.
Depending on the destination netmask:
•
Any remote destination is reachable, i.e. the PPPoA connection acts
as default route (dstmsk=0)
•
Only the remote (sub)net is reachable (dstmsk=1)
•
The actual destination mask will be the default netmask applicable
for destination IP address
•
Only the single remote host is reachable (dstmsk=32)
•
Any valid (contiguous) netmask in case of Variable Length Subnet
Masking (VLSM).
The name of the label.
The source IP address specification for the route to be added when the
link comes up.
PPPoA Commands
REQUIRED
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
401