Instrumentation Programming - New Holland T8010 Manual

General Information
The standard instrumentation controller must be
configured/calibrated before any other controller.
Tractor Standard instrumentation programming is
perfor med through three levels. The first level,
operation setup permits adjustment of display units
and ti re radi us. The s eco nd leve l, co ntr oll er
configuration permits viewing of the current selection
for trac tor m odel ( set dur ing thi rd l eve l) an d
configuration of the electronic controllers that are
expected to be on the TDB (Tractor Data Bus). The
third level requires the use of the service tool to
select the tractor model and fuel tank size.
IMPORTANT: All three levels of programming must
be performed when moving an instrumentation
controller from one tractor to another.
NOTE: When replacing the standard instrumentation
controller the fuel tank size selection must be
selected using the service tool configuration window.
1. STANDARD
INSTRUMENTATION
Configure the instrumentation with the key in the ON
position and the engine not running. Be sure the
batteries are fully charged. Turn off all accessories
during configuration.
Section 55 - Electrical System, Controller - Chapter 6

INSTRUMENTATION PROGRAMMING

1
2
MD05F002
2. PROGRAMMABLE
DISPLAY
Operation Setup
NOTE: Configuration can only be entered within the
first 10 seconds of turning the key switch to the ON
position.
STEP 1
Enter operation setup by pressing and holding the
PROG key for 3 seconds within the first 10 seconds
of turning the key switch to the ON position.
NOTE: If any fault codes are recorded, they must be
corrected before configuration is possible. See Fault
Code Retrieval in this section.
STEP 2
The display will read CONFIG MENU with all menu
items listed. The default highlighted option is ICU.
Press the PROG key.
NOTE: If another option is highlighed use the INCR
or DECR keys to highlight ICU.
55-6-5
RD05G056
MD05F003