Table of Contents
Advertisement
Provisioning and Configuration Guide SoundPoint IP 200W
Configuration Parameters
Note
Name
Network Settings - Defines NAT traversal parameters and local port settings.
SIP_RPORT_ENABLE
SIP_STUN_ENABLE
NETWORK_STUN_SE
RVER
A - 2
The following is an example from the default configuration file:
//------------SIP Server 1 ---------------
%SRV_1_SIP_UA_DATA_SERVER_PORT%:5060
%SRV_1_SIP_UA_DATA_PROXY_ADDR%: "portalphone.net"
%SRV_1_SIP_UA_DATA_SERVER_IS_LOCAL%:0
%SRV_1_SIP_UA_DATA_REREG_TIME%:3600
...
Edit the configuration file for each individual SoundPoint IP 200W gateway
using a standard text editor (such as Microsoft Notepad) and save the file
using the gateway's MAC address (printed on the bottom of the base) and the
extension .cfg as the filename. For example, 00087b0309AC.cfg is the
configuration file for the gateway with the MAC address 00087b0309AC.
The following table shows the configuration parameters.
The Type field specifies one of the following types: uint8, uint16 or uint32. No other
types are supported.
The Size field specifies the size of the field in Type units, for example, if size is 2
and the type is uint16, the entry will be 4 bytes. The total size in bytes may not
exceed 250 bytes.
Type
Size
Permitted Values
uint8
1
0 = disabled
(default)
1 = enabled
uint8
1
0 = disabled
(default)
1 = enabled
uint8
32
IP address or URL,
double quoted
default is Null
Interpretation
Defines whether 'rport' should be used in sip
messages.
If set to 1, 'rport' should be used in SIP
messages.
If set to 0, 'rport' should not be used.
Defines whether Network Address
Translators (NAT) should be detected and
bypassed by means of STUN.
If set to 1, STUN is used.
Note: If STUN requests are blocked in the
firewall, set to 0.
Name of STUN Server.
Note: Change
MAX_DOMAIN_STRING_LENGTH if size is
changed.
Advertisement
Table of Contents
