Table of Contents
Advertisement
Provisioning and Configuration Guide SoundPoint IP 200W
Note
Setting Handset and Gateway Security
3 - 10
Press the End Call key again.
f
Method 2: Configuring Call Groups and Default Line using the
Configuration File
Record each handset IPEI (International Portable Equipment Identity)
a
by pressing the Ok key, then selecting Settings > Handset ID.
IPEI: 023140051241
This handset ID will be used to specify which handsets can connect to
the gateway.
In the configuration file, enable the IPEI matching.
b
%DECT_SUBS_MATCH_IPEI%:1
This enables the specific handset identified with the IPEI to connect to
the gateway.
In the configuration file, define the Handset ID to a specific
c
DECT_SUB_x
%DECT_SUBS_1%:"023140051241"
Specify the call group for each handset.
d
%CALL_GROUPS1%:"1"
If you want VoIP line 1, 2, and 5 and the PSTN line to ring on phone 1, you would
set: %CALL_GROUPS1%:"0,1,2,5" . For more information, refer to
File
on page A-1.
Set the default line type to VOIP for the handset.
e
%USER_PRIMARY_LINE_PP1%:1
Set the default outgoing VOIP line.
f
%USER_VOIP_LINE_PP1%:1
Reset the gateway for changes to take effect.
g
You can set a shared four digit access code to secure handset registration to
your gateway. This is also useful if you are setting up multiple gateways and
want to avoid having handsets incorrectly register to a nearby gateway.
Configuration
Advertisement
Table of Contents
