Polycom SoundPoint IP 200W Provisioning And Configuration Manual page 27

Method 2: For Absolute Time
1. In the configuration file, make the following changes:
Enable scheduled firmware updates.
a
%FWU_POLLING_ENABLE%:1
Configure the polling mode in the configuration file to absolute time
b
(real time).
%FWU_POLLING_MODE%:0
Configure the time of day you would like to schedule a firmware
c
update (using a 24 hour clock).
For example, you want to schedule an update at 4:30 am:
%FWU_POLLING_TIME_HH%:04
%FWU_POLLING_TIME_MM%:30
2. Reset the gateway to make the new configuration values take effect.
To perform a firmware update using checksync notify
1. Press the Volume Up key on any handset to get the MAC address and IP
address of the gateway.
2. Refer to your IP-PBX manual on how to send a checksync notify to the
target device.
Note This will trigger the gateway to immediately compare it's firmware version with what
is stored on the boot server. If it is different, it will automatically start a firmware
update.
Do not turn the power off to the gateway or the phone during this step.
Warning
When the entire update has been successfully completed, the yellow alert box
"Upgraded to <version number>" appears.
While the update is in progress, the SoundPoint IP 200W cannot be used to place
Note
or answer calls.
Polycom recommends that you do not reset the gateway during the update process.
Setting up Your System
3 - 15