Lexicon RV-8 Service Manual page 69

Lexicon
Test:
1. Press each switch and verify that the front panel display indicates the correct name for the switch.
Standby = STANDBY Mode
Left = LEFT MODE
Right = RIGHT MODE
Mute = MUTE MODE
The MAIN switches = MAIN Switch Name, where Switch Name is the name of the Switch that is
labeled on the front panel.
The Zone 2 switches = ZONE 2 Switch Name, where Switch Name is the name of the Switch that is
labeled on the front panel.
The Zone 3 switches = ZONE 3 Switch Name, where Switch Name is the name of the Switch that is
labeled on the front panel.
The Tuner switches = TUNER Switch Name, where Switch Name is the name of the Switch that is
labeled on the front panel.
When all twenty-two switches have been pressed the display will indicate:
"SWITCH TEST All Switches Done."
2. Press the Mode
Encoder Test
This test verifies the operation of the encoder knob.
Setup:
The front panel display should indicate: "ENCODER TEST ENCODER Test."
Test:
1. Turn the encoder knob clockwise until the display indicates:
"ENCODER TEST Encoder Test CCW 24."
2. Turn the encoder knob counter-clockwise until the display indicates:
"ENCODER TEST ENCODER Test Passed."
3. Press the Mode
LED Test
This test verifies the operation of each of the twenty-three front panel LEDs.
Setup:
The front panel display should indicate: "LED TEST LED Test: 11 STBYRed."
button to proceed to the next test.
button to proceed to the next test.
5-15