Lexicon RV-8 Service Manual page 45

Lexicon
10. DVD1 will be highlighted.
11. Press the Menu
12. Using the Menu
arrow.
13. The DVD1 VIDEO IN menu will be displayed. Using the Menu
parameter and select it by pressing the Menu
14. Press the Menu
15. Using the Menu
arrow.
16. The DVD1 COMPONENT IN menu will be displayed.
17. Using the Menu
This will set the RV-8 to up-convert composite and S-video inputs to component video.
18. Press the Menu
19. Using the Menu
arrow.
20. The DISPLAY SETUP menu will open with the ON-SCREEN DISPLAY parameter highlighted. Select
it by pressing the Menu
21. The ON-SCREEN DISPLAY menu will open with the STATUS parameter highlighted. Select the
STATUS parameter by pressing the Menu
"ALWAYS OFF."
22. Press the Menu
23. The video path is now set for testing.
Test:
1. Load a disc into the DVD player and press play.
2. Verify a clean undistorted picture appears on the monitor.
Making The Bias Voltage Adjustment
WARNING
Dangerous voltages capable of causing death are present in this unit. Use extreme
caution when handling, testing, or adjusting.
The bias voltage adjustment should only be performed while the amplifier module is at room temperature
(25°C). The amplifier module must have power applied for at least one minute before the bias adjustment
is performed.
If the amplifier is hot from prior testing, it should be set aside until it has cooled before continuing. Use
caution and follow checkout procedures carefully to ensure correct results.
Note:
It is recommended to use test clips when measuring voltages across pins.
arrow. The DVD1 INPUT SETUP menu will now be displayed.
arrow, scroll to the VIDEO IN parameter and select it by pressing the menu
arrow to exit the DVD1 VIDEO IN menu.
arrow, scroll to the COMPONENT IN parameter. Select it by pressing the Menu
arrow, highlight the VIDEO parameter and press the Menu
arrow three times to exit to the SETUP menu.
arrow, scroll down to the DISPLAYS parameter and select it by pressing the Menu
arrow.
arrow to exit the menu structure.
arrow, scroll to the S-VIDEO-1
arrow.
arrow and change the value of the parameter to
arrow to select it.
4-27