Lexicon RV-8 Service Manual page 42

14. Press the Menu
S-video output of the RV-8.
15. Press the Menu
16. Using the Menu
arrow.
17. The DISPLAY SETUP menu will open with the ON-SCREEN DISPLAY parameter highlighted. Select
it by pressing the Menu
parameter highlighted.
18. Select the STATUS parameter by pressing the Menu
to "ALWAYS OFF." Press the Menu
19. The video path is now set for testing.
Test:
1. Load a disc into the DVD player and press play.
2. Verify a clean undistorted picture appears on the monitor.
3. Pause the DVD player.
4. To test the three remaining S-video outputs (other Main Zone output and the Zone 2 outputs), switch
the S-video monitor output cable on the back of the RV-8 to the next main S-video output connector
and press play on the DVD player.
5. Repeat the above procedure for the two Zone 2 S-video outputs.
6. To test the remaining S-video inputs (2 through 5), reconnect the S-video output cable to the first
main S-video output.
7. In steps 13 and 14 of the above Setup procedure, change the VIDEO IN parameter from S-VIDEO-1
to S-VIDEO-2. Repeat steps 1 to 3 of this test procedure.
8. Repeat Step 7 above to test the remaining RV-8 S-video inputs (3 through 5).
Component Video Input to Component Video Output Test
This test will verify the component video switching function of the RV-8.
Setup:
1. Connect the component video output from the DVD player to the RV-8 component video input 1.
2. Connect the RV-8 main component video output to the component video input of the video monitor.
3. Turn on the DVD player, monitor, and the RV-8.
4. The monitor should display a blue screen.
5. On the RV-8 remote control, press the MAIN button, then press the DVD1 button to select DVD1 as
the input for testing the video paths.
6. Press the Menu
7. Using the Menu
the SETUP menu.
8. The SETUP Menu will appear with INPUTS highlighted.
9. Press the Menu
4-24
arrow to select S-VIDEO-1. This will assign the S-video-1 video input to the Main
arrow three times to exit to the SETUP menu.
arrow, scroll down to the DISPLAYS parameter and select it by pressing the Menu
arrow. The ON-SCREEN DISPLAY menu will open with the STATUS
arrow to exit the menu structure.
arrow on the RV-8 remote control to display the Main Menu.
arrow on the remote, scroll down to SETUP. Press the Menu
arrow again to open the INPUT SETUP menu.
arrow and change the value of the parameter
RV-8 Service Manual
arrow to select