Lexicon RV-8 Service Manual page 43

Lexicon
10. DVD1 will be highlighted.
11. Press the Menu arrow. The DVD1 INPUT SETUP menu will now be displayed.
12. Using the Menu arrow, scroll to the COMPONENT IN parameter. Select it by pressing the Menu
arrow.
13. The DVD1 COMPONENT IN menu will be displayed with the COMPONENT-1 parameter highlighted.
14. Press the Menu arrow to select this video input. This will assign the RV-8 component 1 video input
to the main component video output.
15. Press Menu arrow three times to exit to the SETUP menu.
16. Using the Menu arrow, scroll down to the DISPLAYS parameter and select it by pressing the Menu
right arrow.
17. The DISPLAY SETUP menu will open with the ON-SCREEN DISPLAY parameter highlighted. Select
it by pressing the Menu
18. The ON-SCREEN DISPLAY menu will open with the STATUS parameter highlighted. Select the
STATUS parameter by pressing the Menu
"ALWAYS OFF". Press the Menu
19. The video path is now set for testing.
Test:
1. Load a disc into the DVD player and press play.
2. Verify a clean undistorted picture appears on the monitor.
3. Pause the DVD player.
4. In steps 13 and 14 of the above Setup procedure, change the COMPONENT IN parameter from
COMPONENT-1 to COMPONENT-2. Repeat steps 1 to 3 of this test procedure.
5. Repeat step 4 above to test the remaining RV-8 component inputs.
Composite Video Input to Component Video Output Test
This test will verify the Video Up-Conversion functionality of the RV-8.
Setup:
1. Connect the composite video output from the DVD player to the RV-8's composite video input 1.
2. Connect the RV-8 main component video output to the component video input of the video monitor.
3. Turn on the DVD player, monitor, and the RV-8.
4. The monitor should display a blue screen.
5. On the RV-8 remote control, press the MAIN button, then press the DVD1 button to select DVD1 as
the input for testing the video paths.
6. Press the remote control Menu
7. Using the Menu arrow, scroll down to SETUP. Press the Menu
menu.
8. The SETUP menu will appear with INPUTS highlighted.
9. Press the Menu arrow again to open the INPUT SETUP menu.
10. DVD1 will be highlighted.
arrow.
arrow and change the value of the parameter to
arrow to exit the menu structure.
arrow to display the Main Menu.
right arrow to select the SETUP
4-25