Lexicon RV-8 Service Manual page 41

Lexicon
18. Select the STATUS parameter by pressing the Menu
to "ALWAYS OFF."
19. Press the Menu arrow to exit the menu structure.
20. The video path is now set for testing.
Test:
1. Load a disc into the DVD player and press play.
2. Verify a clean undistorted picture appears on the monitor.
3. Pause the DVD player.
4. To test the four remaining composite outputs (the other Main Zone output, the Zone 2 outputs and the
Zone 3 output), switch the composite output cable on the back of the RV-8 to the next main
composite video output connector and press Play on the DVD player.
5. Repeat the above procedure for the two Zone 2 composite video outputs.
6. To test the remaining composite inputs (2 through 5), reconnect the composite output cable to the
first main composite output.
7. In steps 13 and 14 of the above Setup procedure, change the VIDEO IN parameter from
COMPOSITE-1 to COMPOSITE-2. Repeat steps 1 to 3 of this test procedure.
8. Repeat step 7 above to test the remaining RV-8 composite inputs (3 through 5).
S-video Inputs to S-video Outputs Test
This test will verify the S-video switching function of the RV-8.
Setup:
1. Connect the S-video output from the DVD player to the RV-8 S-video input 1.
2. Connect the first main S-video output of the RV-8 to the S-video input of the video monitor.
3. Turn on the DVD player, monitor, and the RV-8.
4. The monitor should display a blue screen.
5. On the RV-8 remote control, press the MAIN button, then press the DVD1 button to select DVD1 as
the input for testing the video paths.
6. Press the remote Menu
7. Using the Menu arrow, scroll down to SETUP. Press the Menu
menu.
8. The SETUP menu will appear with INPUTS highlighted.
9. Press the Menu right arrow again to open the INPUT SETUP menu.
10. DVD1 will be highlighted.
11. Press the Menu arrow. The DVD1 INPUT SETUP menu will now be displayed.
12. Using the Menu arrow, scroll to the VIDEO IN parameter. Select it by pressing the Menu
13. Using the Menu arrow, scroll to S-VIDEO-1.
arrow to display the Main Menu.
arrow and change the value of the parameter
arrow to select the SETUP
arrow.
4-23