Lexicon RV-8 Service Manual page 63

Lexicon
being executed. Pressing and holding the Mode
menu.
Repair Diagnostics Suite
The repair tests suite is the section where every diagnostic test can be executed individually. Additionally,
the repair test suite allows you to run any single diagnostic test infinitely. The encoder knob is used to
scroll through each diagnostic test. To run any particular test or to move into a sub-menu, use the Mode
button. To back out of a sub-menu or to return out of a test, use the Mode
Sub-menus can be used to partition off groups of tests that deal with a portion of the board. For example,
the SHARC tests and the Trigger tests can be placed in sub-menus. In the repair suite, the SHARC tests
will also include tests as outlined below.
SHARC WCLK
SHARC BOOT
SHARC SDRAM
SHARC WCLK
In the repair suite the ability to set each trigger on and off will be available.
SET TRIGGERS
Trigger 0 ON
Trigger 1 ON
Trigger 0 OFF
Trigger 1 OFF
The following diagnostic selections are available in the repair tests suite:
SH FLASH CHECKSUM
SH DRAM
AVRX FPGA VERIFY
RS232 WRAP TEST
SHARC TESTS
CS49400 TESTS
IR REMOTE
VFD MEMORY TEST
VFD CHAR TEST
VFD BLOCK TEST
PAIR 0
PAIR 1
PAIR 0
PAIR 1
PAIR 0
PAIR 1
SHARC BOOT
PAIR 0/1
SHARC SDRAM
PAIR 0/1
SHARC WCLK
PAIR 0/1
BOOT TEST
SHOW FLASH VERSION
FLASH CHECKSUM TEST
LOAD FLASH
button returns the user to the top-level diagnostic
button.
5-9