Changing The Hydraulic Clutch Fluid - Husqvarna FC 350 2020 Owner's Manual

Table of Contents

Advertisement

11 SERVICE WORK ON THE CHASSIS
11.45
82

Changing the hydraulic clutch fluid

Warning
Skin irritation Brake fluid causes skin irritation.
Keep brake fluid out of the reach of children.
Wear suitable protective clothing and safety glasses.
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
Consult a doctor immediately if brake fluid has been swallowed.
Rinse the affected area with plenty of water in the event of contact with the skin.
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact
with the eyes.
If brake fluid spills on to your clothing, change the clothing.
Note
Environmental hazard Hazardous substances cause environmental damage.
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
V01546-10
V01382-10
Info
Clean up overflowed or spilled brake fluid immediately
with water.
Move the clutch fluid reservoir mounted on the handlebar to a
horizontal position.
1
Remove screws
.
2
Take off cover
with membrane
(FC 350)
4
Fill bleeding syringe
fluid.
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
On the clutch slave cylinder, remove the protection cap
and mount bleeding syringe
piece at the bleeder screw
Only loosen bleeder screw
der to the point where filling is possible.
Info
Clean up overflowed or spilled brake fluid immedi-
ately with water.
Avoid contact between brake fluid and painted
parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
3
.
with the appropriate hydraulic
p. 146)
4
with appropriate hose
5
.
5
on the clutch slave cylin-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fx 350 2020F2201t6F2201t1

Table of Contents