Table of Contents
Advertisement
If there are both clients and servers on the LAN, then the setting
depends on if the local clients will access the remote servers. If they
do, set to Client and set Dial-On-Broadcast in menu 11.2 to Yes to
allow the client queries to trigger the call. If they do not, set it to
Server.
When you are finished, press ENTER at the message 'Press ENTER to
Confirm...' to save your selections, or press ESC at any time to cancel
them.
LAN-to-LAN Application
A typical LAN-to-LAN application is to use the IRT-1002 to call from one
office to another office such that stations on one network have access to
stations on the remote side and vice versa. You will need to configure a
Remote Node in order to dial out to another office.
Remote Node Setup
Follow the procedure in the Remote Node Configuration chapter starting
on page 43 to fill the protocol-independent parameters in Menu 11,
Remote Node Profile. For the protocol-dependent parameters, follow the
ensuing instructions:
1.
Bridge—Make sure this field is set to Yes.
2.
Edit IP/IPX/Bridge—Press the space bar to change it to Yes and
press Enter to go to the network layer options menu as seen
below:
IRT-1000 series User's Guide
83
Advertisement
Table of Contents
