Troubleshooting; Problems Starting Up The Your Irt-1001 Or Irt-1002; None Of The Leds Are On When You Power Up The Router; Connecting The Rs-232 Cable, Cannot Access The Smt - Planet IRT-1001ST User Manual

Troubleshooting

This chapter contains some problems you may run into when using your
router. After each problem description, we have provided some
instructions to help you diagnose and solve the problem.

Problems Starting Up the Your IRT-1001 or IRT-1002

None of the LEDs are on when you power up the router

♦ Check the power cord and the power supply and make sure it is
properly connected to your IRT-1001 or IRT-1002. If the error
persists you may have a hardware problem. In this case you
should contact technical support.

Connecting the RS-232 cable, cannot access the SMT

♦ Check to see if the Your IRT-1001 or IRT-1002 is connected to
your computer's serial port.
♦ Check to see if the communications program is configured
correctly. The communications software should be configured as
follows:
◊ VT100 terminal emulation.
◊ 9600 Baud rate.
◊ No parity, 8 Data bits, 1 Stop bit.
IRT-1000 series User's Guide
127