Planet IRT-1001ST User Manual page 65

6.
PAP Password—This field will only be enabled if the Mutual
Authen. field is set to Yes. Enter in the PAP password to be used
to respond to the far end's authentication request. This field does
not apply to CHAP authentication.
7.
Multiple Link Options: Max Trans Rate—Enter the maximum
data transfer rate between your router and the Remote Dial-in
User. The unit is in bits per second. There are two options for this
field:
◊ 64—At most, one B channel will be used.
◊ 128—A maximum of two channels can be used.
When the Your IRT-1001 or IRT-1002 calls back to the Remote
Dial-in User the maximum data transfer rate is always 64.
8.
Callback Budget Management: Allocated Budget (min)—This
field will set a budget callback time for all the Remote Dial-in
Users. The default for this field is 0 for no budget control.
9.
Callback Budget Management: Period (hr)—This field will set
the time interval to reset the above callback budget control.
10.
Dial-In IP Address Supplied By: Dial-in User—If set to Yes, it
tells the Your IRT-1001 or IRT-1002 to allow a remote host to
specify its own IP address. This is to prevent the remote host from
using an invalid IP address and potentially disrupting the whole
network. If set to No, the remote host must use the IP address
assigned by the Your IRT-1001 or IRT-1002 from the IP pool,
configured below. The default is Yes.
11.
Dial-In IP Address Supplied By: IP Pool—This field tells your
IRT-1001 or IRT-1002 to provide the remote host with an IP
address from the pool. This field is required if Dial-In IP Address
Supplied By: Dial-in User is set to No. You can configure this field
even if Dial-in User is set to Yes, in which case the Your IRT-1001
or IRT-1002 will accept the IP address if the remote peer specifies
one; otherwise, an IP address is assigned from the pool. If Dial-in
User is Yes and this field is No, the remote peer must supply its
own IP address, or communication will not be possible. The
default is No.
IRT-1000 series User's Guide
57