Table of Contents
Advertisement
router to receive an incoming call, you also need to set the default
dial-in parameters in menu 13 (see the Dial-In Configuration chapter
starting on page 53).
1.
Route—Make sure IP is among the protocols in the Route field.
2.
IP Address—Enter the IP address of the gateway at the remote
site (in this case, headquarters). If the remote router is using a
different IP address than the one entered here, your IRT-1001 or
IRT-1002 will drop the call.
3.
Edit IP/IPX/Bridge—Press the space bar to change it to Yes and
press Enter to go to the Menu 11.3—Remote Node Network Layer
Options menu shown below:
1.
Rem IP Address—This will show the IP address you entered for
this Remote Node in the previous menu.
2.
Rem IP Subnet Mask—Enter the subnet mask for the remote
network.
3.
My WAN Addr—Some implementations, especially the UNIX
derivatives, require hosts on both ends of the ISDN link to have
separate addresses from the LAN, and that the addresses must
have the same network number. If this is the case, enter the IP
address assigned to the WAN port of your IRT-1001 or IRT-1002.
IRT-1000 series User's Guide
65
Advertisement
Table of Contents
