Bridge Static Route Setup - Planet IRT-1001ST User Manual

♦ PPP Options: Recv. Authen.—verify that this field is not set to
None.
authentication turned on in order to match to a Remote Node.
Once you have completed filling in the menu, press ENTER at the
message 'Press ENTER to Confirm...' to save your selections, or press
ESC at any time to cancel your selections.

Bridge Static Route Setup

You can configure Bridge static routes for your Bridging applications.
1.
Route Name—For identification purposes enter a name for the
bridge static route.
2.
Active—Indicates whether the static route is active or not.
3.
Ether Address -Enter the MAC address of the destination device
that you wish to bridge your packets to.
4.
IP Address—If available, enter the IP address of the destination
device that you wish to bridge your packets to.
IRT-1000 series User's Guide
Bridging applications must have some sort of
85