will take slightly longer. In addition, if you are using the U-interface, the
system will also take slightly longer to initialize.
At this point, you will be asked if you wish to check if your ISDN line has
been successfully connected to your router. If you select Yes, the router
will perform a loop-back test to check the ISDN line. If the loop-back test
fails, note the error message that you receive and take the appropriate
troubleshooting action.
Ethernet Setup
Menu 3 is used to enter Ethernet related information. Depending on the
protocols (TCP/IP or IPX) on your LAN, you will need to configure each
protocol separately.
General Ethernet Setup
This menu determines the type of Ethernet interface you are using as
well as the filter sets you wish to implement to monitor your Ethernet
traffic. From Menu 3—Ethernet Setup, enter 1 to go to menu 3.1 -
General Ethernet Setup.
30
PLANET ISDN Router