Internet Access Configuration
The following steps describe the set-up procedure to configure your IRT-
1001 or IRT-1002 for Internet access. The information you will need to
provide will be indicated in bold type.
1.
From the Main Menu, enter 4 to go to Menu 4 - Internet Access
Setup, as seen above.
2.
ISP's Name—Enter the name of your Internet Service Provider,
e.g., myisp. This information is for identification purposes only.
3.
ISP IP Addr—Enter the IP Address of the remote gateway at the
ISP's site. If you do not have this data, just leave it blank.
4.
Pri(mary) Phone # and Sec(ondary) Phone Number—Both the
Primary and the Secondary Phone number refer to the number
that your IRT-1001 or IRT-1002 will dial to connect to the ISP.
The router will always call your ISP using the Primary Phone
number first. If the Primary Phone number is busy or does not
answer, the router will call the Secondary Phone number if
available. Once connected, the router will use the BACP
(Bandwidth Allocation Control Protocol) to establish the second B-
IRT-1000 series User's Guide
37