Table of Contents
Advertisement
From the Main Menu, enter 13 to go to Menu 13 - Default Dial-in Setup.
This section will describe how to configure the protocol-independent
fields in this menu. For the protocol-dependent fields, refer to the
appropriate chapters.
1.
2.
3.
4.
5.
56
Telco Options: CLID Authen.—This field sets the CLID
authentication parameter for all incoming calls. There are three
options for this field:
◊ None—No CLID is required.
◊ Required—Must provide CLID, or call is disconnected.
◊ Preferred—If the CLID is available then CLID will be used to
do authentication. If the CLID is not available the call will
continue.
PPP Options: Recv. Authen.—This field sets the authentication
protocol used for incoming calls. User names and passwords are
configured in the next section (Remote users/Dial-in Users
Setup). Options for this field are:
◊ CHAP/PAP—The router will try CHAP first, but PAP will be
used if CHAP is not available.
◊ CHAP—Use CHAP only.
◊ None—No authentication required.
PPP
Options:
determines if Stac compression will be used. The default setting is
Yes.
PPP Options: Mutual Authen.—Some vendors, e.g. Cisco,
implement a type of mutual authentication. That is, the node that
initiates the call will request a user name and password from the
far end that they are dialing to. If the Remote Node that is dialing
in implements this type of authentication, set this field to Yes.
PAP Login—This field will only be enabled if the Mutual Authen.
field is set to Yes. Enter in the login name to be used to respond
to the far end's PAP authentication request. This field does not
apply to CHAP authentication.
Compression—The
setting
in
this
PLANET ISDN Router
field
Advertisement
Table of Contents
