Table of Contents
Advertisement
These filters should inform your IRT-1002 which packets should be
ignored as traffic.
When you are routing IPX packets, the default call filters are defined
as follows:
♦ Block periodical SAP and RIP response messages.
♦ Block NetWare serialization packets.
♦ Allow SAP and RIP inquiry packets.
These call filters prevent the IRT-1002 from making a call to the Remote
Node, thus preventing the expense of an unnecessary phone call.
IPX Ethernet Setup
The first step is to set up the IRT-1002 on the LAN. From menu 3,
select option 3 to go to Menu 3.3—Novell IPX Ethernet Setup, shown
below:
1.
Seed Router—Determine if the IRT-1002 is to act as a seed
router. This value depends on the existing network. If there is a
NetWare server providing the network number, select No. If there
is no NetWare server providing the network number, select Yes.
IRT-1000 series User's Guide
73
Advertisement
Table of Contents
