Connecting Your Computer and Your IRT-1001 or IRT-
1002
For the initial setup of your IRT-1001 or IRT-1002, you must use RS-232
and communications software.
After the router has been successfully installed, you can modify the
configuration through a remote Telnet connection. See the Telnet
Configuration and Capabilities chapter for detailed instructions on using
Telnet to configure your IRT-1001 or IRT-1002.
Connecting the RS-232 Cable to the Router
An RS-232 cable is included in your package. To connect this cable,
connect the 9-pin end of the cable to the DCE port on the router's back
panel. Connect the other end to the RS-232 cable connected to the
serial port (COM1, COM2, or any other COM port) of your computer.
Connecting an ISDN Line to the Router
Plug one end of your ISDN phone line into the socket on the rear panel
of the router labeled ISDN and the other end into the ISDN wall jack.
♦ S/T interface—This can only connect to your NT-1 (Network
NOTE: Do not under any circumstances connect directly to the
ISDN wall jack.
♦ U interface—This allows you to connect directly to your ISDN
20
Termination) device.
wall jack.
PLANET ISDN Router