Table of Contents
Advertisement
These changes allow the RADIUS server to be used with PLANET CLID
authentication, as described in the section below.
Configuring the IRT-1002 for RADIUS Authentication
To configure the IRT-1002 to use the RADIUS server set up in the
previous section, select option 23, System Security, from the main
menu. This will bring you to Menu 23—System Security. Then from this
menu, select option 2, External Server. This will bring you to Menu
23.2—System Security—External Server.
The fields in the System Security - External Server menu are as follows:
1.
2.
3.
106
Active—Determines whether the external security facility is
enabled. If this field contains No, only the built-in dial-up user list
will be used. If this field contains Yes, the built-in dial-up user list
will be searched first, then the external authentication server.
Type—Determines the type of the external authentication server.
At present only the RADIUS type is supported.
Server Address—The IP address of your network's UNIX-based
RADIUS server.
PLANET ISDN Router
Advertisement
Table of Contents
