Lan Setup - Planet WGR-500-4P User Manual

4.3.2

LAN Setup

This page is used to configure the parameters for local area network which connects to the LAN port of your
industrial wall-mount Gigabit router as shown in
subnet mask, DHCP, etc...
Object
IP Address
Subnet Mask
Default Gateway
DHCP
DHCP Client Range
Domain Name
802.1d Spanning Tree
Clone MAC Address
If you change the device's LAN IP address, you must enter the new one in your browser to
get back to the web-based configuration utility. And LAN PCs' gateway must be set to this
new IP for successful Internet connection.
User's Manual of WGR-500-4P and WGR-500-4PV
Figure 4-27. Here you may change the setting for IP address,
Figure 4-27: LAN Setup
The LAN IP address of the Industrial wall-mount Gigabit router and default is
192.168.1.1. You can change it according to your request.
Default is 255.255.255.0. You can change it according to your request.
Default is 192.168.1.254. You can change it according to your request.
You can select one of Disable, Client, and Server. Default is Server, that
the Industrial wall-mount Gigabit router can assign IP addresses to the
computers automatically.
For the Server mode, you must enter the DHCP client IP address range in
the field. And you can click the "Show Client" button to show the Active
DHCP Client Table.
Default is Planet.
You can enable or disable the spanning tree function.
You can input a MAC address here for using clone function.
55
Description